![]() ![]() If the IEEE address(MAC address) for a particular node on the network was 11h 22h 33h 44h 55h 66h, then the LAN controller would be scanning for the data sequence (assuming an Ethernet Frame):ĭESTINATION SOURCE MISC. When the NIC(Network Card) of client receives a BROADCAST frame, as long as the 16 duplications of the IEEE address(MAC address) match the address of the machine to be awakened. Note that, at least 600mA ATX standby current is required to support the LAN card for this function. MAC address MAC address of the targeted server WOL Port The UDP port used for Wake On Lan (typically: 9) Broadcast Address The subnet mask for that section of the network you’d like to broadcast to (default: 255.255.255. The system identification information (probably IP address) is stored on network card and because there is a lot of traffic on the Ethernet. To use Wake On LAN function, you must have a network card with chipset that supports this feature, and connect a cable from LAN card to motherboard WOL connector. This feature is very similar as WOM (Zero Voltage Wake On Modem), but it goes through local area network. Select the computer you want to wake up in the MAC addresses list, and click "Wake On Lan" button on the interface. ![]() If you need more information about the ASUS Download Center, please refer this link.How to use CCGetMAC program do Wake On LAN?įirst, you would use CCGetMAC scan and get the client machine MAC Address. You can download the latest drivers, software, firmware and user manuals in the ASUS Download Center. If the device is offline, just click MAC address to add it to wake up area, and then click Wake up button to turn it on. You can also save your device in the offline list. You can enter the MAC address and click Wake up button to turn on your computer. Please go to Network Tools / Wake on LAN. Please refer to How to reset the router to factory default setting? for how to restore the router to default status.ģ. Note: If you forget the user name and/or password, please restore the router to the factory default status and setup. This utility allows you to easily turn on one or more computers remotely by sending Wake-on-LAN (WOL) packet to the remote computers. Key in your router's username and password to log in. Note: Please refer to How to enter the router setting page(Web GUI) (ASUSWRT)? to learn more.Ģ. Connect your computer to the router via wired or WiFi connection and enter your router LAN IP or router URL to the WEB GUI. Go to Device Manager( in System) -> Select your network adapter and click right button -> Select Properties -> Click Allow this device to wake the computer and Only allow a magic packet to wake the computer.ġ. If you need to use ASUSWRT WOL function, please make sure your have completed the below action. Please make sure your computer or networking adapter supports WOL function. The Router can send a magic packet to wake up your computer in sleep mode/standby mode. ![]() power LED comes on, Mac becomes 'pingable', screen stays dark, but after 5-10 seconds, the Mac goes back to sleep. What happens when I send the WOL packet is one of: absolutely nothing: no lights, no activity, screen remains dark. The WOL (Wake-On-LAN) feature lets you wake up a computer from any device in the network. WOL to an Intel NUC sitting on the same network works as expected. ![]()
0 Comments
Leave a Reply. |